Yellow triangles with the addition -1% are displayed if there is no status of the actuators. The following points may be the cause:
- the distance from the HomePilot to the first actuator is too great
- Change the position of the HomePilot by activating WLAN and searching for a central position.
- If necessary, use additional actuators as repeaters. Each DuoFern actuator with 230 volts helps to transmit DuoFern commands.
- sources of interference are present in the direct vicinity of the HomePilot, e.g. plug-in switchgear, power supply units, etc.
- Select a position for the HomePilot where there are no sources of interference in the vicinity if possible.
- other transmitters on 433MHz are present, e.g. radio headphones, radio loudspeakers, radio alarm systems, etc.
- Switch off the sources of interference.
- the actuator is without function, voltage is switched off
- Check the power supply of the actuator
- Have the actuator checked if necessary
- the actuator has been reset
- register the actuator with the HomePilot again
- the radio stick is defective
- use our contact form and report to the service department