Depending on the device, different device settings are available in the configuration.
The device settings can be made via the Rademacher app and via the PC interface. The images shown here show the Rademacher app.
Voice control:
The SmartHome Box currently supports voice control via Alexa for the RolloPort SX5. In order for the devices to be found by Alexa, the device must be enabled for the service by clicking on the service.
10 minute alarm:
If the alarm is switched on, the operator generates an alarm sound if the door is open for longer than10 minutes is open. The alarm sounds every 10 minutes for 30 seconds.
2000 cycles alarm:
If this function is activated, the operator will emit a short alarm tone at certain intervals after 2000 cycles to signal that the door requires maintenance. End alarm tone. Switch the power off and on again or press the "P" button for 5 seconds.
Back-jump function:
After closing, the back-jump function relieves the drive train by moving briefly (10 mm) in the opposite direction. This is recommended in conjunction with an external emergency release.
Automatic closing:
The operator closes automatically after the selected time has elapsed. If 0 sec is selected, the function is deactivated. Before the door closes automatically, the operator emits an alarm tone for 20 seconds. The light flashes at the same time.
Drive-up speed:
This function allows you to adjust the speed of the open movement.
The closing speed cannot be changed for safety reasons.
Ventilation position:
You can enter a ventilation position that is approached by DuoFern command when closing.