Basic login
As a rule, you only need to activate the DECT logon mode on the RolloTron DECT by pressing and holding the DECT button for approx. 2 seconds (LED flashes green) and then activate the logon mode on the Fritz!Box. Either by pressing and holding the DECT button on the Fritz!Box for approx. 6 seconds or alternatively start the login mode in the Fritz!Box interface.
If the login is not successful, please check the following points:
Requirements / restrictions on the part of AVM (Link to the source)
- No DECT repeater (under "Telephony > DECT > Monitor") must be logged on to the FRITZ!Box.
- A maximum of ten smart home devices from another manufacturer can be registered with the FRITZ!Box.
"Deactivate "Reduce DECT radio power
- Click on "Telephony" in the user interface of the FRITZ!Box .
- In the "Telephony" menu, click on "DECT".
- In the "Radio power" section, deactivate the "Reduce DECT radio power" option.
- Click "Apply" to save the settings.
Enable support for CAT-iq 2.0
In the factory settings, CAT-iq 2.0 support is active in the FRITZ!Box. If you have disabled this setting, enable it again:
- Click "Telephony" in the FRITZ!Box user interface.
- Click on "DECT" in the "Telephony" menu.
- Click on "Base station".
- In the "Troubleshooting" section, activate the "Support for CAT-iq 2.0 compatible devices active" option.
- Click on "Apply" to save the settings.
You should also check other settings in the "Telephony" and "DECT" menus and adjust them if necessary.
Activate DECT base station
Security
Access protection (deactivated)
