Basically, when the sun/wind sensor is registered with a receiver, the sun control is activated and the sun position is set to 100%. In addition, the following points must be observed in some.
However, with some receivers, such as the Troll Basis DuoFern, the automatic sun function can only be activated if a total runtime has been set beforehand. Therefore, set a suitable runtime before registering the sun/wind sensor.
For the following receivers, a runtime must be set before the sun automatic can be activated.
- Troll Base DuoFern 5615
- To set the total running time, close the shutter completely. Then press and hold the open button and the clock button simultaneously until the roller shutter is completely open.
- To set the total running time, close the shutter completely. Then press and hold the open button and the clock button simultaneously until the roller shutter is completely open.
- Troll Comfort DuoFern 5665
- To set the total runtime, call up menu item 9-2 and enter the total runtime in seconds or close the shutter completely and then press and hold the Up key in this menu item until the shutter is completely open
- older tubular motor actuators 9471
- with these devices the running time can only be set with the help of a control panel, for example HomePilot, manual control panel or HomeTimer.
- older Connect actuators 9477
- The running time of these devices can only be set with the help of a control panel, e.g. HomePilot, centralized handset or HomeTimer.
The sun control function must be activated for the respective device.
- You can deactivate the sun automatic on the device for some devices, please check the automatic states.
- If you additionally control the devices with a hand-held transmitter 4-channel Auto/Manu or a central unit, make sure that the automatic is switched on.
For devices that have a connection for their own sun sensor, the sun mode must be set appropriately.
- Troll Comfort DuoFern 5665
- Select the mode 3 in the menu 9-9-3
- RolloTron Comfort DuoFern 1800/1805/1840
- Select mode 3 in menu 9-9-3
- for older devices, select mode 3 in menu 7-8-3.