Login via key on the device:
Briefly press the connection button on the 1-10V control device. The DuoFern 1-10V control device sends out a login signal and the STATUS LED flashes green. The login mode remains active for 120 seconds.
After successful login, the STATUS LED lights up constantly green and the connected consumer is briefly switched on or off.
If the middle indicator light is red, the login has failed. This can have the following reasons:
- 20 DuoFern transmitters are already registered
- an unsuitable device has been registered
- the deregistration of a DuoFern transmitter is attempted although the transmitter was not registered at all.
Registration via remote registration function:
If the 1-10V control unit is no longer accessible and is already connected to the HomePilot®, the manual control unit or the HomeTimer, you can alternatively use the remote login function. This can be called up in the respective control panel and the login mode can be started via it without having to press the button on the device.
Logon by radio code:
In order to connect the 1-10V control unit with the HomePilot®, the manual control unit or the HomeTimer, the radio code can be used as an alternative. The radio code can be found on the back of the DuoFern actuator or on a label.
Important! In the 1-10V control unit, the radio code is only active for approx. 120 minutes after the power is switched on.
Basic note:
Lighting control
With the DuoFern 1-10V control unit you can connect electronic ballasts (ECG's) with a 1-10V interface and
usethem to dim and control e.g. LED's, LED strips or fluorescent lamps.
An integrated relay switches the ballast on or off (approx. 5 seconds) time delayed after reaching 0%.
Control of external devices with 1-10V interface
External devices with a 1-10V (DC) interface (e.g. pumps, fans or ventilators etc.) can also be connected and controlled.
Use in the DuoFern network
You can integrate the DuoFern 1-10V control device into a DuoFern network to use the functionality of e.g. DuoFern sensors and of DuoFern transmitters like the HomePilot®.
Manual operation on site
For manual operation on site, an additional external switch/button can be connected.