First possibility:
Radio code
:You have the possibility to activate the login function of the motor by entering the radio code in the HomePilot, in the central control unit or in the HomeTimer. The radio code activates the login mode by the HomePilot directly, in the case of the central control unit and HomeTimer, the UP button must be pressed after entering the radio code.
Important: The radio code is only active for 2 hours after power supply. If necessary, briefly interrupt the power supply to the radio tubular motor.
Second possibility:
Remote registration
:If you have already registered a HomePilot, a central control unit or a HomeTimer with the tubular motor and would now like to register another transmitter or sensor with the tubular radio motor, for example, the remote registration function is available in the devices mentioned.
HomePilot > Configuration > Actuators > Advanced settings > Start remote login
Central operating unit > System settings > Menu 1-1-2-3 > Select actuator > Press UP key.
HomeTimer > Menu item 9-9-8 > Select actuator > Press UP key.
There is no specific time window to be observed for this function after power supply.
Third possibility:
Login function via external line (cord switch setter
)The radio tubular motor has a white or gray connection line, via which the motor can be controlled by an external pushbutton. However, this line can also be used to set end points and activate the motor's log-on mode. Connect the lines of the same color to the cord switch setting device.
- Switch in middle position
- Press and hold Set button
- Set switch in open position (ON)
- After 5 seconds, the motor jerks briefly > Release the Set key immediately > Motor jerks again
- Motor is now in logon mode for 2 minutes
Caution: If you continue to hold down the Set key after the first jerk, the motor switches to end point mode after a further 5 seconds and adjusts the end points.