The follow-up time is the time that the motion detector waits after the last movement until it is reported that there is no more movement. This time is set to one minute at the factory.
The time can be changed on the device by pressing and holding the Manu key. After approx. 4 seconds, the LEDs indicate which values have been set. The five LEDs indicate the following values. 20 seconds, 1 minute, 3 minutes, 10 minutes and 30 minutes. If you want to set other values, this is possible via the HomePilot, under advanced settings you will find the item staircase function. This value can be seen in the same way as the overrun time.
In the HomePilot you have the possibility to enter values from 100ms to 55 minutes. The entry is always made in 100 ms steps. For example, for a switch-on time of 5 minutes, the entry is 3000 x 100 ms.