Yes, exclusively for "Electronic Rademacher motors" from year of manufacture 2000 and only directly via the device. End point setting is not possible for motors connected in parallel. End point setting is not possible via any other device such as HomePilot type 9496-3, DuoFern hand control type 9493-1 or DuoFern HomeTimer type 9498. To set the end points via the Troll Basis DuoFern, proceed as follows:
Set the upper end point.
1. Press the keys simultaneously and keep them pressed.
The sun LED flashes red to acknowledge this.
2. Release the keys as soon as the roller shutter has reached the desired position for the upper end point.
The shutter stops and the upper end point is saved.
Set the lower end point.
3. Press the keys simultaneously and hold them down. The roller shutter moves down.
The sun LED flashes red to acknowledge this.
4. Release the keys as soon as the shutter has reached the desired position for the lower end point.
Changing or correcting the end points
5. Move the roller shutter to the middle position and
readjustthe respective end point.