The registration of the coding switching device is done in the same way as the normal hand transmitters. Once the device is registered, you can later change the code as often as you like. A new registration is not necessary.
The code must be entered two or three times within 10 seconds and confirmed each time with # or *. For this reason, it is recommended that you leave the factory code of 0000 for registration and adapt the code to your needs later. You can also program a one-digit code for programming and change it later.
- Check whether the code you think is the correct one is actually correct by entering it and then pressing the # or * key, the keypad must light up faintly green, if the keypad flashes red, the code is incorrect. In this case, the opening code must be reset to the master code.(See operating instructions point 4.3)
- Activate the login mode of the garage door drive by pressing the S key for approx. 1 second. (the display will show a small green dot on the RolloPort S2, and a 0 on the SX5) You now have 10 seconds to complete the next step.
- Now quickly enter the valid coding TWICE and confirm each time with the desired key # or *, i.e. 0000 *, immediately again 0000*.
- If the login was successful, the actuator will beep once. If the login was not, repeat from point 2