When setting the end points, the sequence is very important.
Before the end point setting can be started, the gate must be closed. If the gate cannot be closed with the minus key, please press the P key for approx. 5 seconds until the 1 appears in the display, then briefly tap the P key, the 1 flashes, then press the minus key until the gate is closed. Press and hold the P key again until the zero turns. The operator is thus in the correct starting position.
- Press and hold the P key for approx. 5 seconds --> the display shows 1
- Tap the P key --> the 1 flashes
- Press and hold the Plus key until the gate is completely open --> a rotating zero will appear in the display and about half way an L will appear for a few seconds. This will set a reference point. Make sure you release the key immediately when the gate is open, you can also release the key a little earlier and then move to the desired point by tapping it for a short time.
If no L, or the L appears immediately after the start, the microswitch on the motor head must be checked, it may then be bent or defective. - Tap the P key --> the 1 stops flashing.
- Tap the Plus key --> the 2 appears
- Tap the P key --> the 2 flashes
- Press and hold the Minus key until the gate is completely closed --> a rotating zero will appear in the display and about half way down an L will appear for a few seconds. This will set a reference point.
Be sure to release the key immediately when the gate is closed, you can also release the key a little earlier and then move to the desired point by tapping it briefly. - Tap the P key --> the 2 stops flashing
- Tap the Plus key --> the 3 appears
- Tap the P key once --> the gate opens automatically and switches off at the upper end point, the 3 flashes
- Tap the P key twice --> the gate closes automatically and switches off at the lower end point, the 3 flashes
- Tap once --> the P button the 3 stops flashing
- Tap the Minus key twice --> the 1 appears
- Press and hold the P key for approx. 5 seconds --> the zero rotates
The setting is now complete