To ensure that your roller shutter stops at the correct position at the top and bottom, you must set the end stops. You have already set the upper and lower end points during initial commissioning.
If required, you can call up and change the "Set end points" function in the menu at any time.
- To do this, open the menu by pressing the M key.
- Scroll to the "Set end points" function with the UP key (symbol: double arrow between two horizontal lines) and confirm with the OK key. EndP flashes.
- First set the upper end point by pressing the UP key until the desired upper end point is reached
- then confirm with the OK key.
- Now set the lower end point by pressing the DOWN key until the desired lower end point is reached.
- Then confirm with the OK key to save the setting.
- Then exit the menu by pressing the M key.