In this checklist you will find all the conditions and requirements that must be met in order to put the HomePilot into operation.
Checklist:
-
Network
- Router with DHCP function enabled
- Free LAN port on the router
- The HomePilot and the PC/smartphone used for configuration are in the same network.
- A freely accessible mains socket (230 V / 50 Hz) is available
- A standard computer with a current Internet browser is available. We recommend Firefox, Chrome, Safari, Edge
- Smartphones, tablets, etc. on which the app is to be configured are present in the same W-LAN network. The devices are allowed to communicate with each other.
- Internet connection is available
- The HomePilot has unrestricted access to the network, or the following ports are free:
Port |
Service |
22 TCP |
SSH |
443 TCP |
VPN / HTTPS |
53 UDP |
DNS |
80 TCP |
HTTP |
123 UDP |
NTP |
587 TCP |
SMTP |
8080 TCP |
HTTPS |
10000 UDP |
Camera new Discovery |
88 TCP |
Camera Images / Motion Detection |
-
Actuators
- The correct devices for the desired applications are available and mounted and connected according to the operating instructions
- Radio tubular motors: DuoFern ONLY, FernoTron is not compatible.
- UP actuators: ONLY the 9471-1 tubular motor actuator can be used to control tubular motors. The universal actuator 9470-1 is used for consumers up to 1500Watt
- Radio codes are available with the corresponding assignment (which code is for which device)
- devices without radio code are accessible e.g. Troll Basis DuoFern, RolloTron DuoFern
- Suitable end points are set for all tubular motors
- The correct devices for the desired applications are available and mounted and connected according to the operating instructions
-
Sensors
-
- Environmental sensor is mounted in a suitable place (there is a minimum distance of 60cm under the sensor, otherwise wind measurement
isnot possible)
Free view in the relevant directions is available (note the formation of shadows due to different sun heights over the course of the year) - Wireless sun sensor is charged. If necessary, charge manually with an 11Watt energy saving lamp
- Environmental sensor is mounted in a suitable place (there is a minimum distance of 60cm under the sensor, otherwise wind measurement
-