Depending on the device, different device settings are available in the configuration.
The 230V Multiple Wall Controller consists of two parts. When you call up the Multiple Wall Controller under Switch actuators, the settings of the switch actuators are displayed. More information can be found under the following link. Device setting for switch actuators
If you call up the Multiple Wall Controller under Transmitters, the following settings will be displayed.
The device settings can be done via the HomePilot app and via HomePilot interface. The images shown here show the HomePilot App.
Assignment of the button to the switching location:
The 230V Multiple Wall Controller consists of a transmitter part and a switching actuator to which a consumer can be connected directly. By default, the consumer is switched on and off with the uppermost button group 1. Here you have the possibility to change the assignment or to cancel it completely.
Key illumination:
The 230V Multiple Wall Controller has 6 LEDs for key illumination. Here you can define how bright the LEDs should shine.