You have the possibility to register certain cameras of the manufacturer Abus at the HomePilot, if they support the ONVIF protocol T.
The following steps are necessary for the registration.
- Commission the camera via PC interface according to the manufacturer's instructions.
Notes:
The camera interface can usually be opened by entering the IP address of the camera in the browser.
A password must be assigned during initial commissioning.
The user of the Abus camera is installer - Check the firmware of the camera in the Dashboard. Possible updates can be found on the Abus homepage.
- Under Storage - Single image capture - Capture parameters, activate the "Event-controlled single image capture" function. Save the setting.
- In order to be able to use the camera's motion detection in HomePilot, please activate "Enable motion detection" under Detectors - Motion detection.
- Now you can start the login mode on the HomePilot, if the camera is in the same network, as the HomePilot, it will be displayed after a short time as a new device. Click on log in and enter the access data. User is installer, password is the one assigned to call the camera interface.
You can use the camera's motion detection as an event in triggers to trigger complex scenes.
You can also have images sent to you via email through the HomePilot as soon as motion is detected. This is done by activating the notification in the trigger under THEN.
In addition, all functions of the Abus camera can of course still be used.
Note: In the HomePilot app and on the HomePilot interface, only single images are displayed. You can retrieve a live image via apps from Abus. Info about this can be found on the Abus website.